Xilinx KC724 IBERT Getting Started Manual page 18

Chapter 1: KC724 IBERT Getting Started Guide
1.
X-Ref Target - Figure 1-15
2.
X-Ref Target - Figure 1-16
18
In the Project Panel, click VIO Console below UNIT 1: SCLK2 Control (VIO)
(Figure 1-15).
Figure 1-15: Project Panel - VIO Console (GTX)
The clock sources on the SuperClock-2 module are controlled from the VIO Console.
Click on the Si5368 Start button
Note:
The ROM address values for the Si5368 and Si570 devices (i.e., Si5368 ROM Addr and
Si570 ROM Addr) are preset to 19 to produce an output frequency of 125.000 MHz. Entering a
different ROM address changes the reference clock(s) frequency. The complete list of
pre-programmed SuperClock-2 frequencies and their associated ROM addresses is provided in
Table 1-2, page 22.
Figure 1-16: Si5368 Address, Frequency and Start Button
www.xilinx.com
UG931_c1_15_080812
(Figure 1-16) to enable the clock output.
The ROM address value for the
Si5368 clock multiplier is preset to 19
(125.000 MHz)
Si5368 start button
KC724 IBERT Getting Started Guide
UG931 (v1.0) October 23, 2012
UG931_c1_16_080812