Table of Contents
Advertisement
4.
X-Ref Target - Figure 1-9
There is one IBERT demonstration design for each GTX Quad on the KC724 board, for a
total of four IBERT designs. Four other demonstration designs are included that show
other board features (the use of these designs are described in the README file within the
SD card). All eight designs are organized and stored on the SD card as shown in
Table 1-1: SD Card Contents and Configuration Addresses
5.
KC724 IBERT Getting Started Guide
UG931 (v1.0) October 23, 2012
Select the GTX IBERT demonstration with the System ACE SD controller SASD CFG
switch, SW8. The setting on this 4-bit DIP switch
configure the FPGA. A switch is in the ON position if set to the far right and in the OFF
position if set to the far left. For the Quad 115 GTX IBERT demonstration, set
ADR2 = ON, ADR1 = ON, and ADR0 = ON. The MODE bit (switch position 4) is not
used and can be set either ON or OFF.
Figure 1-9: Configuration Address DIP Switch (SW8)
Demonstration
ADR2
Design
GTX Quad 115
GTX Quad 116
GTX Quad 117
GTX Quad 118
LED Scroll
DIP Switches
Push Buttons
USB/UART
Place the main power switch SW1 to the ON position.
www.xilinx.com
Running the GTX IBERT Demonstration
(Figure
SASD CFG
SW8
ADR0
ADR1
ADR2
MODE (Not Used)
UG931_c1_09_072412
ADR1
ADR0
ON
ON
ON
ON
ON
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
OFF
OFF
OFF
ON
OFF
OFF
OFF
1-9) selects the file used to
Table
1-1.
13
Advertisement
Table of Contents
