King gates ELEVO620 Instructions And Warnings For Installation And Use page 39

5.2 - PROGRAMMING OF THE BUTTON
LINKED TO THE "LOCK/AUX" OUTPUT
This procedure allows for programming the button of the radio
control linked to the "Lock/AUX" output (terminals 11-12).
To use this function, the Lock/AUX output must be set to courtesy
light – see Paragraph 13.1.
1. PRESS THE RADIO BUTTON FOR 1 SECOND: The red "radio"
LED turns on in the fixed mode
2. PRESS THE START BUTTON FOR 1 SECOND: The red "radio"
LED remains lit in fixed mode and the red "error" LED turns on
in fixed mode
3. PRESS THE DESIRED BUTTON OF ALL THE TRANSMITTERS TO
BE PROGRAMMED: The red "radio" LED flashes and the red
"error" LED ramins lit in fixed mode
4. PRESS THE RADIO BUTTON UNTIL RADIO LED TURNS OFF OR
WAIT 20 SECONDS TO EXIT THE PROCEDURE
5.3 - PROGRAMMING OF THE BUTTON
LINKED TO THE ON-BOARD COURTESY LIGHT
This procedure allows for programming the button of the radio
control linked to the on-board led courtesy light.
To use this function, the Lock/AUX output must be set to courtesy
light – see Paragraph 13.1.
1. PRESS THE RADIO BUTTON FOR 1 SECOND: The red "radio"
LED turns on in the fixed mode
2. PRESS THE SET BUTTON FOR 1 SECOND: The red "radio" LED
remains lit in fixed mode and the yellow "set" LED turns on in
fixed mode
3. PRESS THE DESIRED BUTTON OF ALL THE TRANSMITTERS
TO BE PROGRAMMED: The red "radio" LED flashes and the
yellow "set" LED ramins lit in fixed mode
4. PRESS THE RADIO BUTTON UNTIL RADIO LED TURNS OFF OR
WAIT 20 SECONDS TO EXIT THE PROCEDURE: The red "radio"
LED and the yellow "set" LED turn off
5.4 - DELETING ALL MEMORISED
TRANSMITTER
This operation deletes all memorized transmitters from the
memory.
1. PRESS THE RADIO BUTTON FOR 4 SECONDS AND RELEASE
WHEN RADIO LED: The red "radio" LED flashes (if not, consult
Paragraph 14.1)
2. PRESS THE RADIO BUTTON AGAIN FOR 1 SECOND: The red
"radio" LED flashes fast
3. MEMORY DELETION COMPLETED FLASHES: The red "radio"
LED turns off
5.5 - DELETING A SINGLE TRANSMITTER
This operation deletes a single transmitter from the memory.
1. PRESS THE RADIO BUTTON FOR 4 SECONDS AND R ELEASE
WHEN RADIO LED FLASHES: The red "radio" LED flashes (if
not, consult Paragraph 14.1)
2. PRESS THE SET BUTTON FOR 1 SECOND: The red "radio" LED
flashes and the yellow "set" LED turns on in fixed mode
3. PRESS A BUTTON ON THE TRANSMITTER YOU WISH TO
CANCEL: The red "radio" LED flashes and the yellow "set"
LED flashes
4. PRESS THE RADIO BUTTON UNTIL RADIO LED TURNS OFF OR
WAIT 20 SECONDS TO EXIT THE PROCEDURE: The red "radio"
LED and the yellow"set" LED turn off
5.6 - REMOTE (TOOLS FREE) TRANSMITTER
PROGRAMMINGA
This procedure enables you to program a new transmitter without
accessing the control unit, but keeping close to it.
To run the procedure you will require a previously programmed
transmitter, to inherite its functions.
1. ON A PREVIOUSLY PROGRAMMED TRANSMITTER, HOLD
DOWN BUTTONS 1 AND 2 TOGETHER FOR 4 SECONDS
2. ON THE TRANSMITTER YOU WANT TO PROGRAM, HOLD
DOWN BUTTONS 1 AND 2 TOGETHER FOR 4 SECONDS
- 37 - - 37 -