Ip Line And Ip Phone Configuration; Select An Extension With An Ip Line Attached - Epygi Quadro2x Configuration Instructions

Epygi Technologies

5 IP Line and IP Phone Configuration

This section provides step-by-step instructions on configuring IP lines connected to the Quadro LAN.
The following steps are detailed below:
1. Select an extension with an IP line attached (or add an extension and attach an IP line to it).
2. Configure the attached IP line.
3. Reset and restart the phone to complete automatic configuration.
5.1

Select an Extension with an IP Line Attached

By default the Quadro comes with a number of extensions. Some of these extensions are already
attached to IP lines (they start with extension 31). To verify or edit the settings of an extension, on the
Extensions Management page select the checkbox in the leftmost column of the extension and click
Edit at the top of the table. Check the Attached Line list to make sure it is set to an IP Line.
It is also possible to manually add an extension and attach an IP line to it.
To add an extension
1. Log in to the Quadro as the administrator.
2. Choose Extensions Management from the Users menu.
3. Press the Add button and enter a number into the Extension text box, for example 79 (see
Figure 2).
4. Click Save.
To edit the extension settings
1. From the Extensions Management page, select the extension and press Edit.
2. On the Extensions Management – Edit Entry page, click on the General Settings tab.
3. From the Attached Line drop-down list, choose an IP line to attach to the extension, IP Line 9
in this example (see Figure 3).
4. Click Save.
5. Click on the SIP settings tab to specify the SIP settings of the extension (mandatory). Click
Save to apply the changes.
6. Specify other settings as required (see Manual II: Administrator's Guide of the
corresponding release).
Figure 2 Extensions Management – Add Entry page
PAGE 5
Auto Configuration of Quadro LAN IP Phones
29-Dec-05