Step 2 Plug In The Megarac G3 Card Into The Host System And Attach Internal Cables; J3 Service Connector; J4 Jtag (Joint Test Action Group) Ice (In-Circuit Emulator) Connector - American Megatrends MegaRAC G3 User Manual
American megatrends megarac g3 controllers: user guide
Hide thumbs
Also See for MegaRAC G3:
- Brochure (4 pages) ,
- Quick install manual (2 pages) ,
- Datasheet (2 pages)
Table of Contents
Advertisement
Step 2 Plug in the MegaRAC G3 Card into the Host System and Attach
Internal Cables
Physically plug in the MegaRAC G3 card into any available PCI slot inside the host
system.
J3 Service Connector
This jumper is used exclusively for servicing the MegaRAC G3 card. J3 is not described
in this document.
J4 JTAG (Joint Test Action Group) ICE (In-Circuit Emulator) Connector
This header is used to debug and service the MegaRAC G3 card. J4 is not described in
this document.
Chapter Two : Installing Your MegaRAC G3 Card
Cont'd
7
Advertisement
Table of Contents
