Cannot Power On the Host System Remotely
Problem
Cannot remotely power on, power off, or power cycle the host system.
Symptom
When connected to the MegaRAC G3 remotely (using the GUI), power on, power off,
and power cycle does not work properly.
Solution
The user should make sure that the feature cable is connected properly from the G3 card
and the host system's main board and chassis. The wall AC adapter must be connected to
the MegaRAC G3 card in order for power control options to operate properly.
Complete Flash
Problem
Deciding whether to do a Complete flash instead of selecting individual modules during a
firmware upgrade.
Symptom
After flashing the new firmware to the MegaRAC G3, there are unexpected errors.
Solution
Whenever there is a change in Config section of the new firmware image, the user must
perform a Complete flash. Otherwise the default selected modules are sufficient for
flashing.
130
MegaRAC G3 User's Guide