Table of Contents
Advertisement
MegaRAC® G4 Card Layout and Connection Guide
Plug the AC Adapter here (optional)
To the MegaRAC G4
(USB In)
To Host System's USB Port
Network
RJ-45 Network Cable
VGA Splitter Cable
To the Monitor
To the MegaRAC G4
(15-pin Female)
(15-pin Female)
To the Host System's
VGA Port
(15-pin Male)
The MegaRAC G4 USB Cable is specifically designed for the MegaRAC G4, revision E PCB and newer
revisions only. Do not use the MegaRAC G4 USB Cable for any other MegaRAC device.
Step 2 Plug in the MegaRAC® G4 card into the Host System and Attach
Internal Cables
Physically plug in the MegaRAC® G4 card into any available PCI slot inside the host
system.
J10 RS232 Serial Port
USB In
VGA In
Host System's Motherboard PCI Slot
Warning
Secure the card into the chassis.
Plug the card into a standard PCI slot.
Secure the I/O shield of the card
to the card mounting on the chassis.
Power On Cable
J18 MegaRAC Feature Connector
(Runs between the
J5 Recovery/ Configuration
MegaRAC G4 and the
MegaRAC Feature
Power On Header located
Connector Cable
on the Host System's
(not to drawn to scale)
Motherboard)
J16 & J17 Must Be Shorted
J14 & J15 I2C Clock/Data PCI Bypass
I2C Cable
(Optional, with Limitations. Runs between the
MegaRAC G4 and the IPMB Header located
on the Host System's Motherboard)
Chapter Two : Installing Your MegaRAC® G4 Card
Power On Cable
(Runs between
the MegaRAC G4
and the Power On
Switch located
on Front Panel of
the Host System)
Reset Switch Cable
(Runs between
the MegaRAC G4
Reset Switch Cable
and the Reset
(Runs between
Switch located
the MegaRAC G4
on Front Panel of
and the Reset
the Host System)
Header located
on the Host
System's
Motherboard)
5
Advertisement
Table of Contents
