Hardware Setup,
Continued
BIOS
After you have established a physical connection from your host system's serial port to
you MegaRAC G3 card, you must enable Remote Access in your AMIBIOS.
Step
1
2
3
4
5
6
7
8
132
MegaRAC G3 User's Guide
Description
From the host system's terminal, enter the AMIBIOS setup.
Confirm that your Onboard Serial Port you are using is enabled.
Enter the Remote Access Configurations menu.
Set the Remote Access setting to [Serial].
Set the Serial Port Number to [COM1] or [COM2] depending on the serial
(COM) port you are using.
Set the Serial Port Mode baud rate you desire. By default, it is set to [19200
8,n,1].
If available, you can set the Post-Boot Support option. When enabled, the
MegaRAC G3 attempts to output the DOS screens or the initial windows text
screens. This is really handy when you want to see the OS Boot Menu.
Save and Exit the BIOS.