Required Tools And Materials; Decommissioning And Disposal - Siemens SIMATIC NET RUGGEDCOM RST916C Installation Manual

Introduction
1.3 Required Tools and Materials
Power Supply Terminal Blocks
Chassis Ground Terminal
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RST916C:
AC power cord (16 AWG)
USB Type-B console port cable
CAT-5E (or higher) Ethernet cables
Flathead screwdriver
Phillips screwdriver
Torx screwdriver
4 x M5 or #10-24 screws
a
HI AC/DC variant only
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
equipment. Recycling and disposal must be done in accordance with local
regulations.
4
Pluggable terminal blocks for connecting one or more power
sources. For more information, refer to
14)" and
Protects the device from power surges and accumulated static
electricity. For information about grounding the device, refer to
"Connecting Power (Page
Tools/Materials
a
"Power Supply Specifications (Page
14)".
For connecting power to the device.
For connecting to the RUGGEDCOM ROS console
interface.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For attaching mounting brackets to the device.
For mounting the device to a panel.
Installation Manual, 04/2021, C79000-G8976-1490-03
"Connecting Power (Page
27)".
Purpose
RUGGEDCOM RST916C