Trouble Shooting - Formax FD 38Xi Operator's Manual

TROUBLE-SHOOTING
TROUBLE
Control panel is not
illuminated.
Fold table stop not moving
when "Test"/ "Start" is
pressed.
"Cover Open" image is
displayed.
"Paper out" image is
displayed.
"Paper Jam / Misfeed"
image is displayed.
Black marks on the folded
paper.
Fold is skewed.
Stacker belts do not turn.
Documents are wrinkled or
crunched.
Infeed tray lever does not
work
Double feeding forms
Not feeding documents
Power loss
POSSIBLE CAUSE
Power switch turned off.
No power at the wall outlet.
No power to the machine inlet.
No power to the control panel.
Internal electrical failure
Fold table is not plugged in.
Electrical or mechanical failure
Cover open
Magnetic switch is broken.
Infeed tray is empty.
Paper misfeed
Paper jammed at exit of folder
Infeed tires, separator, and/or
fold rollers are dirty.
Infeed tray is out of adjustment. Turn skew adjuster knob to remove the skew.
Broken drive belt, worn drive
gear.
Fold tables are not inserted
correctly.
Piece of paper or other material
is stuck in the fold table.
Broken spring
Documents stuck together
More tension is needed
Feed tire or separator worn
Feed tires aredirty
Feed tires or separator worn
Circuit Breaker tripped
Under adverse conditions,
power input level may drop
below acceptable limits
24
REMEDY
Turn on power switch.
Check wall outlet.
Check power cord for frayed/broken wires.
Press the button on the circuit breaker.
Call for service.
Plug in fold table.
Call for service.
Close cover.
Call for service.
Place documents on the infeed tray.
Reload paper and press "Counter Reset"
button.
Remove paper and press "Counter Reset"
button.
Clean the parts with approved roller cleaner
and rejuvenator.
Call for service.
Remove and reinstall fold tables. Be sure
they're properly positioned.
Remove object from the fold table.
Call for service.
Jog forms to remove static electricity.
Adjust the infeed tension lever (page 5, Fig. 8)
Call for service
Clean feed tires
Call for Service
Press black reset button next to power inlet.
When power is restored, turn off machine, then
turn on again to restore normal operations.