Trouble Shooting - Formax FD 332 Operator's Manual

(5) Trouble Shooting

Trouble
The paper does
not feed properly
The machine does
not operate even
after the Start/Stop
key is pressed.
Wrinkles appear on
the paper.
Improper fold
position
Possible Cause
Paper sticks just after it is
printed
Stains on the paper separator
Stains on the paper feed rubber
roller.
The paper separator is worn out.
The volume of the paper stacked
on the paper feed table is not
enough.
Paper jam inside the unit.
Paper sticks just after it is
printed
Stains on the paper separator
Stains on the paper feed roller
Stains on four paper fold rollers
Table 1 and 2 are not properly
set.
Paper jam in Table 1 and 2
The total length of the paper is not
standard size.
Jog the paper sufficiently or feed the paper
after it is dry.
Clean the paper feed separator using
approved cleaner.
Clean the paper chips or ink on the paper
feed roller with approved cleaner.
Replace the paper separator with a new
one.
If the volume on the paper feed table is not
enough, it does not feed since the paper
detection lever is installed.
Stack 20 sheets or more.
Detach Table 1 and 2 and remove the paper
in the unit.
Jog the paper sufficiently or feed the paper
after it is dry.
Clean the paper separator using the
approved cleaner.
Clean the paper chips or ink on the paper
feed roller with the approved cleaner.
Clean the stain on four fold rollers using
approved cleaner.
Reset properly.
Detach Table 1 and 2 and remove the
jammed paper out.
Measure the total length of the paper and adjust
using the fine adjustment knob
19
Measures