Technical Support - Christie Solaria One Retrofitting Manual

Retrofitting with adolby ims3000 imb

Hide thumbs Also See for Solaria One:

User manual (136 pages)

Service manual (88 pages)

Instruction sheet (20 pages)

Table of Contents

22. Return the Christie IMB to Christie.

Enabling the IMB

After installing the Dolby IMB in the projector, you must enable it and activate marriage.

Complete the Marriage wizard to display secure content. Marriage permissions are required to

complete marriage and only Christie accredited technicians are authorized to activate projector

marriage.

The projector must not be in standby mode when activating marriage as the IMB is not powered.

1. Connect the projector to AC power and turn it on.

2. On the touch panel controller (TPC), select Menu > Administrator Setup > Content

Devices Configuration.

3. In the IMB Installed list, select Doremi (Dolby).

4. Add the Solaria One projector as a device on the Dolby IMS3000.

For more information, refer to the Adding the Series II Projector as a device on the Dolby

IMS3000 technical bulletin (P/N: 020-200488-XX).

5. To verify that the IMB has been installed correctly, in the Operational Status region of the Main

panel, verify that the IMB Status icon is green.

If the icon is red, an error exists or the IMB has not been installed correctly. Use the

dissasembly and installation procedures to check the IMB installation.

6. Log on to the projector with marriage permissions.

7. Select Menu > Service Setup > IMB Marriage.

8. Complete the Marriage wizard.

9. Select Finish.