7. Place the faceplate on its side.
8. Insert the PIBS1 board as shown and insert the 3D Sync, RS 232, PIBS1, HDMI A/LEFT, and
HDMI B/RIGHT nuts removed in step 14 of the disassembly procedure to hold the board in
place. Do not fully tighten the nuts.
9. Using the two screws set aside in step 16 of the disassembly procedure, secure the PIBS1
board to the faceplate. Torque the screws to 10 in-lb.
10. Torque the 3D Sync, RS 232, PIBS1, HDMI A/LEFT, and HDMI B/RIGHT nuts to 10 in-lb.
11. Secure the support bracket from the conversion kit to the PIBS1 board using the two screws
removed in step 12 of the disassembly procedure. Torque the screws to 10 in-lb.
Installing the Christie Solaria One IMS3000 IMB Faceplate Kit Instruction Sheet
020-103421-02 Rev. 1 (11-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Retrofitting the Solaria One projector with a Dolby IMS3000 IMB
11