10. Rotate the assembly 180 degrees.
11. Using a 2.5 mm ball hex driver, remove the right screw securing the Christie IMB to the
faceplate. Set the screw aside.
12. Using a 2.5 mm hex driver, remove the two screws on the bottom of the PIBS1 board. Set the
screws and support bracket aside.
13. Carefully separate the Christie IMB from the faceplate. Set the Christie IMB aside.
Installing the Christie Solaria One IMS3000 IMB Faceplate Kit Instruction Sheet
020-103421-02 Rev. 1 (11-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Retrofitting the Solaria One projector with a Dolby IMS3000 IMB
6