ABB AC 800F Mounting And Installation Instructions Manual page 358

13
)
Engineering station *
Ethernet
Ethernet board
Ethernet module
Extra low voltage with
- F -
Failure (LED)
FF/HSE-Modul FI 840F
FF/HSE Link
FF/HSE Speed
Fiber optic cable
Fieldbus module
*)
Component of the Freelance 2000 System
PC or laptop with MS Windows NT and Control Builder F software. Used
by the Freelance 2000 system operator for configuration, commissioning,
and documentation.
Serial bus system to DIN/ISO 8802, Part 3 (IEEE 802.3).
PC plug-in board for connecting engineering station and operator station
to Ethernet system bus. Built in the PC central unit. Provided with an AUI
connector and a BNC jack for connecting 10Base2 network cables.
The Ethernet modules provide for communication with a supervisory
system, e.g. the Freelance 2000 system.
The following module are under development: 10/100BaseTx module for
connecting twisted-pair cables, and 10/100BaseFL module for direct
connection of fiber-optic
communication with fieldbuses based on the Ethernet standard.
→ 10Base2 modules, →AUI modules
protective separation from other circuits which may be earthed (PELV)
according to IEC 364-4-41:1991.
Indicates hardware and software errors of the AC 800F.
Fieldbus link for linking local peripherals, based on the Fieldbus-
Foundation High-Speed Ethernet Standard.
The lower, green LED on the RJ45 connector of the FF/HSE module,
indicating the link state:
• Off
No active link, neither 10Mbit nor 100 Mbit. No
communication possible.
• Green static
Active link. Communication possible, but currently no
data traffic.
• Green flashing Active link. Communication is possible
The the upper, yellow LED on the RJ45 connector of the FF/HSE
module, indicating the the transmission rate::
• Off
The module has recognized a 10 Mbit/s data link.
• Yellow static
The module has recognized a 100 Mbit/s data link.
→ 10BaseFL network cable
The AC 800F fieldbus modules are driven via the CPU board in the
AC 800F housing.
The data transferred by the fieldbus modules is processed according to
the configured link modules and then transmitted to the operator station
via the Ethernet modules and the system bus. The processing results are
output via the fieldbus modules an then transmitted to the fieldbus
→ FF/HSE module FI 830F,
devices.
→ Serial module FI 820F, → CAN module FI 810F
cables. These module will
→ Profibus module FI 830F,
Glossary
allow for
13-7