Table of Contents
Advertisement
8
Replacing the buffer battery
• Remove the battery holder:
take the two small faces of the
holder and pull it out.
• If the battery module is on
(State LED is lighted), the Batt
low LED will light up yellow.
• Open
the
SY 809F: slightly press your
fingers on the upper and lower
edge of the holder
• Replace battery SB 808F; ob-
serve the battery polarity
• Assemble the battery holder
• When inserting the battery
holder make sure the contact
pins are on the left hand side
• Insert the battery holder into
the slot on the module front
panel and press it in until it
snaps in.
• Make sure that the battery
holder is not canted.
8-6
battery
holder
Accessories
Hide quick links:
Advertisement
Chapters
Table of Contents
