Patient Application; Figure 13. Thread And Tighten Wristband - Nonin WristOx2 3150 Operator's Manual

Using the WristOx Model 3150
2,

Patient Application

The WristOx Model 3150, is usually worn on the back of a patient's wrist.
2,
NOTE: The wristband can be used to secure the device to an alternate location (e.g., the
upper arm or a bed rail).
NOTE: Ensure the wristband fits comfortably on the patient's arm. Do not over-tighten the
wrist band.
1. Verify the wristband has been attached properly to the device (figure 9 & 11). If the
wristband has not been attached to the device, see "Attaching the Wristband."
2. Place the device on the patient's wrist.
3. If using the multiple use wristband, thread the rounded end of the wristband through the
plastic ring. Pull the strap through the plastic ring until the device fits comfortably on the
wrist (figure 13).
4. Fold the wristband back over the plastic ring (figure 14) and attach the fastener to the
wristband (figure 15 or figure 16). Wrist circumference will determine which fastener is
used.
5. If using the single-use wristband, align the fastener button with the appropriate size hole
on the opposite side of the wristband, ensuring that the wristband fits comfortably and
securely. Once the correct size is found, fold tamper proof fastener button over to close
the fastener. Fastener will pop into place when closed (figure 17). Note, once tamper-
proof fastener is close, the wristband cannot be readjusted.
Figure 13: Thread and Tighten Wristband
23