Figure 18. Removal Of Single Use Wristband; Figure 19. Apply Sensor To Patient - Nonin WristOx2 3150 Operator's Manual

Hide thumbs Also See for WristOx2 3150:

Table of Contents

Using the WristOx

Model 3150

6. Attach the sensor if it is not already connected (see "Attaching the Sensor").

7. Apply the sensor to the patient (figure 19). Refer to the sensor Instructions for Use for

proper sensor application sites and sensor application cautions and warnings.

8. When in Spot Check Activation Mode, inserting a finger in the sensor automatically turns

the device on. When the finger is removed, the device turns off in approximately 10

seconds.

NOTE: Depending on the sensor and ambient light conditions, it may take up to 3 minutes

for the device to turn off.

9. If the device does not turn on, verify battery orientation, activation mode, and sensor

connection. Refer to "Troubleshooting" for additional information.

Figure 18: Removal of Single Use Wristband

Figure 19: Apply Sensor to Patient

Table of Contents