(9) Loosen 2 screws
fixed. Tighten them again to strain the timing belt.
Note: Make sure that the timing belt is not twisting.
12.4.4 RADF open/close switch
[A] Disassembly
(1) Disconnect 3 connectors.
(2) Remove one screw and take off the RADF open/
close switch with the bracket attached.
(3) Remove one screw and take the RADF open/
close switch apart from the bracket.
[B] Assembly and adjustment
(4) Attach the RADF open/close switch to the bracket.
Connect the connectors as shown in the right
figure.
October 2000 © TOSHIBA TEC
which have been temporarily
Connector
RADF open/close switch
Orange
Gray
12-8
1
1
White
MR-3011/3012 DISASSEMBLY