Adjustment Of Image Skew - Toshiba MR-3011 Service Manual

12.15 Adjustment of image skew

Assemble the scanning guide and jump plate using the adjustment screw located at the hinge so that the gap
between them is 1.1mm.
Perform copying test. If the image does not satisfy the specification, make finer adjustment by adjustment screw
at right side of hinge.
Note: Loosen the fixing screw to perform the adjustment, and make sure to tighten it when it is finished.
fixing screw
adjustment screw
Platen guide
Jump plate
October 2000 © TOSHIBA TEC 12-20 MR-3011/3012 DISASSEMBLY