Toshiba MR-3011 Service Manual page 4

PREPARATION FOR TRANSPORTATION OF COPIER
Before transporting a copier on which mounts the MR-3011/3012, take off the MR-
3011/3012 or insert a gaggers underneath the MR-3011/3012 as shown in the
following figures.
1. Use pieces of the corrugated board came in the package of MR-3011/3012 or
equivalent as the gaggers. Insert the gaggers as shown in the figure, then close
the MR-3011/3012.
2. Make sure that the height positioning stud is not in contact with the original
glass.
The height positioning stud is not
Gagger
in contact with the original glass.
Height positioning
stud
Gagger
Gagger