Table of Contents
Advertisement
CellAdvisor 5G User's Guide
4
Push the battery an additional 1/8 to 1/4 of an inch to fully seat the battery. The battery will seem to snap into position when the
connector is seated.
5
Slide the battery door back on, making sure to engage the center and end hooks of the door.
6
Tighten the thumb screw.
Installing battery
CAUTION:
The battery pack that came with your instrument is Lithium Ion and it may, if not connected correctly, lead to
explosion. In case you need to replace the battery, you must use one of the same kinds or compatible ones. You
must dispose a battery according to your local safety and environmental regulation.
NOTE:
It is recommended that you turn off the instrument to replace the battery. However, if you do not want to interrupt the
current test, you can leave the module tuned on with the AC power adapter plugged in.
Powering the instrument
Power is supplied to the instrument by the battery or the AC power adapter. For the CellAdvisor 5G, the adapter is supplied with the
instrument. Use of AC power adapters or batteries other than those supplied with your CellAdvisor 5G, is not recommended as other
slices/modules may be supplied with incompatible adapters or batteries. When supplying power using AC power adapter, you need
to verify that you have the correct adapter.
The following figure shows the label on the adapter that ship with CellAdvisor 5G.
15
Advertisement
Table of Contents
