Removal Of The Terminal Board Enclosure - Emerson Bettis SCE300 Installation, Operation And Maintenance Manual

Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
4.9

Removal of the Terminal Board Enclosure

Using a 5 mm Allen key, loosen the four screws and remove the cover.
Figure 9
NOTICE
When removing the cover assembly or terminal block cover on existing installations, follow all
safety rules as pertaining to the site.
NOTICE
Be careful to not damage the joint surfaces of the terminal cover or seal during removal.
Installation
Removal of the terminal board enclosure
Section 4: Installation
February 2020
21