Emerson Bettis SCE300 Installation, Operation And Maintenance Manual page 35

Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
NOTICE
The actuator configuration does not need to be performed in the order as indicated by the
following steps. Each parameter can be set independently.
Configuration of the actuator parameters is conducted via the following components:
•
•
•
•
•
•
Figure 15
Actuator Configuration
Two rotary selector switches SW6 and SW4 for actuator configuration
Enter pushbutton SW5 (confirmation pushbutton)
Dip switch SW3 (enable configuration function)
Green LED indicating power ON (switched on when power supply is available)
Red LED for Enter confirmation (ON once configuration is confirmed)
Mechanical stops
Configuration of the actuator parameters
Section 6: Actuator Configuration
February 2020
31