Replacing Wear And Tear Components - Electrolux Combi TOUCH User Manual

3. Clean the internal glass especially near the edge. See
figure below;
4. With the door open, press the two top and bottom retaining
clips as shown in the figure;
5. Clean the other side of the glass and the interspace
surfaces between the two doors.
6. Refit the internal glass into the clips and close the oven
door.
7. Clean regularly the drip collector drain pipe ("A") using a
pressure water jet;
Once in a while spray a detergent solution inside the drain
pipe before cleaning with water jet.
8. Remove the metal cover ("B") and clean regularly the
single check valve ("C") using a pressure water jet;
Once in a while spray a detergent solution over the single
check valve before cleaning with water jet.
CLICK !
D
9. Clean regularly the small gutter ("D") with the brush
supplied with the appliance;
Food probe
Clean the food probe regularly to ensure its efficiency. The
probe must be cleaned by hand, using lukewarm water and
neutral soap, then rinsed with clean water.
IMPORTANT
Pay particular attention when handling the probe;
remember that it is a sharp object, therefore handle
it very carefully, even during cleaning.
F.1.5

Replacing wear and tear components

There are parts, whose damage happens because of the
ordinary use during a period, which are not covered by the
manufacturer warranty.
B
A
C
51