Electrolux Combi TOUCH User Manual page 27

• Set the delta value for the cavity temperature;
• Eventually set the core probe temperature;
The display shows the set humidity value, for the cavity
temperature the delta value set and for the probe the
current and the target values;
NOTE!
If creating more phases at least one of them
must be driven by probe with the cavity
temperature set as a delta from the food
core temperature probe value. Otherwise
the START button is deactivated and the
message "Eco delta cooking program invalid
pops up.
AUTOMATIC
Eco Delta cooking
Eco Delta cooking
Delta progressive
• Touch button to start the cycle.
• Once the cavity temperature is reached, load the oven
and insert the food probe in the product.
At the end of the cycle the display shows the consumptions (if
available) as a recap message.
Eco Delta progressive
2. This cycle allows to cook the food maintaining always the
link between the cavity temperature and the food core
probe temperature.
AUTOMATIC USER
Eco Delta cooking
Eco Delta cooking
Delta progressive
• Set the delta value between the cavity and the core
probe temperatures;
• Set the core probe temperature;
The display shows:
– as for the cavity temperature the set value and the
target delta value;
– as for the food probe temperature the current and
the target values;
• Touch button to start the cycle.
• Once the cavity temperature is reached, load the oven
and insert the food probe in the product.
At the end of the cycle the display shows the consumptions (if
available) as a recap message.
It is possible to save and store the performed presets; see how
to manage them at Presets management paragraph of this
chapter.
USER
30
%
50% 15
°C
20°C 51
°C
02:35 h:m
70°C
7
AUTOMATIC
Preset dynamic
5
°C
25°C 25
°C
70°C
REGENERATION
This cycle is a set of categories and cooking cycles to reheat
chilled food keeping the humidity controlled. It works as a
standard automatic cycle.
To start a regenerating cycle, proceed as follows:
1. Once accessed the cycle, select the required item among
plate or tray;
AUTOMATIC
Plate
Custom
Probe
Timer
2. Select the cycle type and set the parameters defining the
status of the food to regenerate;
3. Touch button to start the cycle.
CAUTION
Cold food shall not to be added to the
cavity for regeneration while the Maintain-
ing (HOLD) phase is operating.
At the end of the cycle the display shows the consumptions (if
available) as a recap message.
STATIC COMBI
USER
This cycle simulates static cooking using a more gentle air
distribution. The oven performs the cycle in manual mode
without the fan adjusting.
AUTOMATIC
Cycles+
Low temper. Eco Delta
cooking cooking
Static combi Proving
Advance FSC FSC low risk
guide
Dehydratating Fresh pasta
pastorization
To start a static combi cycle, proceed as follows:
1. Select a preset, if created;
If the cavity temperature is lower or higher then the set
temperature the oven starts a cooling down or a preheat-
ing phase.
2. When the oven has reached the cooking temperature,
load the oven and, if necessary, insert the food probe in
the product.
3. Close the door and touch
The fan speed is not adjustable.
At the end of the cycle the display shows the consumptions (if
available) as a recap message.
USER AUTOMATIC
Custom
Load
Standard
Humidity content
Dry Medium
Cooking control
Probe
23
50°C
USER
PRESET 1
1
20
Regeneration
50
%
25
Sous vide
100°C
01:30
FSC high risk
guide
01:30 h:m
Smoker
button to start the cycle.
USER
Full
Moist
Timer
°C
USER
%
°C
:00
27