System Reset; Power Cycling; Standby State For Ha Nodes - Oracle Acme Packet 3900 Hardware Installation And Maintenance Manual

Table of Contents

Advertisement

To sync & activate, run 'activate-config' or 'reboot activate'.
ACMEPACKET#
Type reboot.
2.
ACMEPACKET# reboot
-----------------------------------------
WARNING: you are about to reboot this SD!
Type Y at the confirmation prompt to proceed with the reboot.
3.
Reboot this SD [y/n]?: y

System Reset

Resetting the Acme Packet 3900 via the reset pushbutton on the rear of the chassis
performs a cold reboot. This action is the equivalent of disconnecting the power from
the system and then reconnecting it. There is no orderly termination of tasks, and the
system shuts down abruptly. You should only reset the Acme Packet 3900 when it
becomes unstable and no other means of gaining administrative control is possible.
During a system reset, certain files are not closed properly, and they may become
corrupted. If an unclean shutdown is detected, filesystem recovery/repair will be run to
ensure the system returns to a stable state. Filesystem verification also runs every 30
boots as a precautionary measure.
Note:
Always try to reboot first from the ACLI before performing a cold reset. Only
reset the system as a last resort.
Insert a rigid paperclip-sized tool into the small hole on the rear of the chassis. The
system immediately resets and begins its initialization and boot sequence.

Power Cycling

Power cycling the Acme Packet 3900 is the process of turning the chassis off and
then on again. When power cycling, it is imperative that you wait at least 10 seconds
between power down and power up to ensure that all components are completely
powered down before restarting the system.

Standby State for HA Nodes

When performing hardware maintenance on the Acme Packet 3900, it is best to
minimize any risk of interrupting network traffic or losing data. If the Acme Packet
3900s are configured as an HA node, you should only work on the node that is in
standby state.
Chapter 5
Standby State for HA Nodes
5-3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Acme Packet 3900 and is the answer not in the manual?

Table of Contents