Troubleshooting Using Alarm Codes; When An Alarm Occurs - ESPEC Platinous Series User Manual

Troubleshooting

8.1 Troubleshooting Using Alarm Codes

DANGER
!
The Platinous Series is equipped with an alarm that sounds when problems occur as well as self-check
features which appear on the instrumentation panel display. Display alarm codes and their content are
given in the alarm table on the following pages. Follow the steps as indicated.
For problems not found with self-checks,
If the issue is not resolved after taking the prescribed action, contact the place of purchase or
America.

8.1.1 When an Alarm Occurs

The chamber will be in one of the states listed below when an alarm occurs. The alarm is cleared in a
different way depending on what your needs are at that time. Procedures for clearing the alarm in each of
these cases are given on the following pages.
• Running in the constant mode
• Running in the program mode but not needing to continue after clearing the alarm
• Running in the program mode and needing to continue after clearing the alarm
84
ELECTRIC SHOCK! Before intervening with power circuits, shut
OFF primary power supply at the primary switch.
Working with primary power supply ON runs the risk of electric shock.
Shut OFF power from the main power breaker BEFORE opening
the electric parts compartment door or the water circuit
compartment door.
See "Operator Error and Additional Troubleshooting" on page 95.
Platinous User's Manual
Espec North