Setting A Connected Computer's Resolution And Refresh Rate - SMART Board GX Series Installation And Maintenance Manual

Chapter 3
Connecting computers and other devices
2. Select the source using one of the following methods:
Using the Side Toolbar menu
a. Open the Side Toolbar menu by sliding
either of the Side Toolbar menu handles
(located on either side of the screen)
toward the center of the screen.
b. Tap the Input Select icon
The Input Selection dialog box appears.
NOTE
Three dots ••• appear below inputs (USB Type-C, HDMI, HDMI 1, HDMI 2, OPS and DP) with a device
connected.
3. Tap the computer's input source or use the navigation keys on the remote control to select the input
source and then press the OK button.
The device's output appears on the display's screen.
TIP
You can configure the display to automatically switch to the newest input, lock the current source, or
choose other priorities or input options.
For more information, see Source settings on page 83.

Setting a connected computer's resolution and refresh rate

This table presents the recommend resolutions and refresh rates for the display's inputs:
Input source
USB Type-C, Display Port
Alternate Mode
1
HDMI
HDMI 1
HDMI 2
VGA
Display Port
1
Located on the display's front connector panel.
smarttech.com/kb/171744
Using the remote control
Press the Input Select
control.
.
Resolution
3840 × 2160
3840 × 2160
3840 × 2160
3840 × 2160
1920 × 1080
3840 × 2160
button on the remote
Refresh rate
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
38