ADInstruments AD2817C Operation Manual page 97

AD2817C Operation Manual
BIN3L:
BIN3H:
SEC L:
SEC H:
At limit setup page, press
to modify value. When data input is valid, press
and when data input isn't valid, press ENTER to exit, as ESC
1) AUX
Perform the following steps to turn on or off auxiliary item.
a) Select "AUX" item through
Figure4-21.
b) Press ▲ or ▼ key to select "ON" or "OFF".
c) Press ENTER or ESC key to exit.
2) MODE
Primary parameter's high and low limits can be set in the form of absolute tolerance and
percentage tolerance.
Figure 4—22 Primary parameter's tolerance mode
Perform the following steps to modify primary parameter's tolerance mode:
a) Select "MODE" item through
Figure4-22.
b) Press ▲ or ▼ key to select "ABS" or "PER".
c) Press ENTER or ESC key to exit.
3) NOM
Perform the following steps to set nominal value:
a) Select "MODE" item through
Figure4-23. The current nominal value is displayed at the second line with unit
corresponding with current primary parameter's type and multiple at unit column.
b) Press ENTER key to enter data modification status, and the data which is going to
be modified twinkles.
c) Press or
d) Press ▲ or ▼ to modify value to 0,1,2,3,4,5,6,7,8,9, and the first value could be
selected to be "-".
e) If decimal point needs repositioning, press
low limit of primary parameter 3;
high limit of primary parameter 3;
low limit of secondary parameter;
high limit of secondary parameter;
or
or
or
or
key to select data that needs modifying.
key to select item, press ▲ or
ENTER key to enter data modification,
key at limit setup page, as shown in
key at limit setup page, as shown in
key at limit setup page, as shown in
or
32
▼
key works.
key to select the decimal
key