ADInstruments AD2817C Operation Manual page 92

AD2817C Operation Manual
modified twinkles, press
key to ensure data input, and
f) Press ESC key to exit.
3) FILT
Perform the following steps to set filtering depth:
e) Select "FILT" through
f) Press ▲ or ▼
g) Press ENTER key to enter data modification, and the data which is going to be
modified twinkles, press
key to ensure data input, and
h) Press ESC key to exit.
4) SRES
Perform the following steps to set source resistance:
d) Select "SERS" through
e) Press ▲ or ▼ key to select "100 " or "30 ".
f) Press ENTER key or
10) BIASM (bias mode)
11) BIAS (bias source)
AD2817C has internal bias voltage of -5V +5V and internal bias current of -50mA
+50mA.
Before using bias function, bias mode should be selected:
d) Select "BIASM" through
▲ or ▼ key to change value. Then press
ESC key to cancel.
Figure 4-10 Delay setup
or key, as shown in Figure4-11.
to add or minus filtering depth.
▲ or ▼ key to change value. Then press
ESC key to cancel.
Figure 4-11 Filtering depth setup
or key, as shown in Figure4-12.
ESC key to exit.
Figure 4-12 Resistance selection
or key, as shown in Figure4-13.
27
ENTER
ENTER