ADInstruments AD2817C Operation Manual page 102

AD2817C Operation Manual
4) DELIM
AD2817C supports to send several common ending symbols:
LF:
line change symbol (ASCII ode 100);
CR
enter symbol (ASCII code 13);
CR+LF:
enter to change line
Perform the following steps to select:
a) At system setup page, select "DELIM" through
4-33.
b) Press ▲ or ▼ key to select ending symbol that needs setting.
c) Press ENTER key or ESC key to exit.
5) FETCH
The measurement result can be automatically sent or queried when the instrument
communicates with PC through RS232C or GPIB.
Perform the following steps to select:
a) At system setup page, select "FETCH" through
4-34.
b) Press ▲ or ▼ key to select fetch mode.
c) Press ENTER key or ESC key to exit.
6) TRGEG
There are two kinds of trigger edges:
RISE:
Measurement starts at trigger pulse's rising edge;
FALL:
Measurement starts at trigger pulse's falling edge.
Figure 4-32 Baud rate setup
Figure 4-33 Ending symbol selection
Figure 4-34 Fetch mode
37
or key, as shown in Figure
or key, as shown in Figure