Chapter 4 Operation Instructions; Turning On The Instrument; Function Operations; Primray Parameter Setup - ADInstruments AD2817C Operation Manual

AD2817C Operation Manual

Chapter 4 Operation Instructions

4.1 Turning on the Instrument

1) Press POWER key to turn on instrument.
2) The instrument enters test status after self-inspection, as shown in Figure 4-1.

4.2 Function Operations

4.2.1 Primray parameter setup

AD2817C has the following primary parameters: L
Press PARA A key, and the primary parameter changes. Or pressPARA A, then
switch parameter. If the primary parameter changes, secondary parameter also changes:
Ls, Lp
Cs, Cp
Rs, Rp
Z
L2A, L2B

4.2.2 Secondary parameter setup

AD2817C has the following common secondary parameters: θ° (angle), θr (radian), R, X, Q,
D.
AD2817C also has the function of measuring DC resistance and transformer parametersw.
Secondary parameters differ with parimary parameters:
Primary parameters
C , C , R
S P
L
S
L2A, L2B
Press PARA B key, and the secondary parameter changes. Or pressPARA B, then
switch parameter. After parameter being modified, auto DCR function will be cancelled.
Figure 4-1 Test status
—— Q;
—— D;
—— X;
—— θr (radian);
—— N
, R , Z
S P
, L
P
, L , C , C , R
S P S P S
Secondary parameters
θ° (angle), θr (radian), R, X, Q, D
θ° (angle), θr (radian), R, X, Q, D, DCR
N, 1/N, M ,R2
20
, R , Z, L2A, L2B.
P
to
to