ADInstruments AD2817C Operation Manual page 101

AD2817C Operation Manual
1) BUS
There are 3 BUS types:
OFF:
communication interface off;
RS232:
RS232C communication interface is turned on, and GPIB communication function
is turned off;
GPIB:
GPIB (IEEE488) communication interface is turned on, and RS232C
communication function is turned off.
Perform the following steps to select BUS type:
a) At system setup page, select "BUS" through
4-30.
b) Press ▲ or ▼ key to select "RS232C", "GPIB" or "OFF".
c) Press ENTER key or ESC key to exit.
2) ADDR
Address can be changed from 0 to 31.
Perform the following steps to select:
a) At system setup page, select "ADDR" through
4-31.
b) Press ▲ or ▼ key to add or minus address.
c) Press ENTER key to enter data modification status and modifying data twinkles,
then press or
or ▼ key to modify value. Then press ENTER key to ensure the modification, or ESC
key to give up it.
d) Press ESC key to exit.
Figure 4-31 Communication address setup
3) BAUD
AD2817C's RS232C supports 8 common baud rates: 4800bps, 9600bps, 11520bps,
12800bps, 14400bps, 19200bps, 28800bps, and 38400bps.
Perform the following steps to select baud rate:
a) At system setup page, select "BAUD" through
4-32.
b) Press ▲ or ▼ key to select baud rate.
c) Press ENTER key or ESC key to exit.
Figure 4-30 System setup
key to select the data that is going to be modified, press ▲
36
or key, as shown in Figure
or key, as shown in Figure
or key, as shown in Figure