Table of Contents
Advertisement
Hardware Preparation and Installation
1
!
Caution
!
Warning
1-22
3. Remove chassis or system cover(s) as necessary for access to the
CompactPCI.
Figure 1-9. PMC Module Placement on MCPN750A
Inserting or removing modules in a non-hot swap chassis with power
applied may result in damage to module components. The MCPN750A is
a hot swappable board and may be inserted in a hot swap chassis, such as
a CPX2000 or a CPX8000 series chassis with power applied.
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
4. Carefully remove the MCPN750A from its CompactPCI card slot
and lay it flat, with connectors J1 through J5 facing you.
Computer Group Literature Center Web Site
2288 9806
Advertisement
Table of Contents
