Mvme760 Transition Module Preparation - Motorola MVME1603 Installation And Use Manual

MVME760 Transition Module Preparation

The MVME760 transition module (Figure 1-4) is used in
conjunction with the MVME1600-001 base board. The features of
the MVME760 include:
Configuration of Serial Ports 3 and 4
The synchronous serial ports, Serial Port 3 and Serial Port 4, are
configurable via a combination of serial interface modules (SIMs)
and jumper settings. The following table lists the synchronous
serial ports with their corresponding SIM connectors and jumper
headers.
Synchronous
Port 3 is routed both to board connector J7 and to the HD26 front
panel connector marked
connector J2. Four serial interface modules are available:
A parallel printer port
An Ethernet interface supporting both AUI and 10BaseT
connections
Two EIA-232-D asynchronous serial ports (identified as
and on the front panel)
COM2
Two synchronous serial ports (ports 3 and 4)
Board
Port Connector
Port 3 J7
Port 4 J2
SERIAL 3
EIA-232-D (DCE and DTE)
EIA-530 (DCE and DTE)
Hardware Preparation and Installation
Panel SIM
Connector Connector
SERIAL 3 J6
None J4
. Port 4 is available only at board
1
COM1
Jumper
Header
J9
J8
1-15