Step 8. Turn Off The Analyzer; Hibernate; Shutdown - Agilent Technologies PNA Series Installation And Quick Start Manual

Installing Your Analyzer

STEP 8. Turn Off the Analyzer

STEP 8. Turn Off the Analyzer
The PNA can be turned off with or without the use of a mouse.
Without a Mouse - BRIEFLY Press the green front panel On/Off switch.
With a Mouse - Minimize the PNA application, then click Start, Shutdown.
Both methods present a dialog box asking What do you want the computer to do? (If
your PNA does not present a dialog box, type "power on" in the index of the PNA Help
system to learn more.)
Using a mouse or front panel keys (Navigation plus Enter), choose an action:
• Log off (close programs and disconnect from the network)
• Restart (shutdown and start)
• Hibernate (see below)
• Shutdown (see below)

Hibernate

The On/Off switch changes from green to yellow when power is OFF.
The current instrument state is saved to the PNA hard disk drive.
When the PNA is powered ON, this instrument state is loaded, thus saving time over a full
system boot-up.
A password is not required to resume PNA operation from Hibernate mode.
For more hibernate information, type "hibernate" in the index of the PNA Help system.

Shutdown

The On/Off switch changes from green to yellow when power is Off.
The current instrument state is NOT saved to the PNA hard disk drive.
When the PNA is powered ON, a full system boot-up is performed and the PNA powers-up
in the Preset settings.
IMPORTANT Only turn off the PNA using Shutdown mode when preparing to service it, or
provide security via password protection.
Note: Repeatedly doing either of the following two actions WILL cause damage to the PNA
Hard Disk Drive.
1. Only in an emergency should the power cord be removed from the PNA without first
being put in Hibernate or Shutdown mode.
2. If the PNA is locked and you cannot operate the mouse or keypad, turn OFF the PNA by
pressing and holding the power button for at least four seconds.
2-10 E8356-90001