Power Supply And Blown Fuses; Verification Of The Power Supply; Verification And Connection Of Power Cable - Agilent Technologies E5070B ENA Series Installation And Quick Start Manual

Power Supply and Blown Fuses

Before turning on the E5070B/E5071B power, check the following.

Verification of the Power Supply

Confirm that the power supplied to the E5070B/E5071B meets the following requirements:
Voltage
Frequency
Maximum power consumption

Verification and Connection of Power Cable

The three-wire power cable attached to the E5070B/E5071B has one wire serving as a
ground. Using this power cable allows the E5070B/E5071B to be grounded, thereby
protecting you against electrical shock from the power outlet.
Step 1. Confirm that the power cable is not damaged.
WARNING NEVER use a power cable showing any sign of damage. Faulty cables can cause
electrical shock.
Step 2. Use the supplied cable to connect between the power cable receptacle (Figure 2-11 on
page 35) on the rear panel of the E5070B/E5071B and a three-wire power outlet with the
grounding prong firmly connected in the ground slot.
WARNING Use the supplied power cable with grounding wire to securely ground the
E5070B/E5071B.
Figure 2-10 shows the power cable options.
Chapter 2
*1. Switched automatically by the E5070B/E5071B in conformity to the voltage used.

Power Supply and Blown Fuses

Requirements
90 to 132 VAC or 198 to 264 VAC
47 to 63 Hz
350 VA
Installation
*1
31