Introduction
Electrical Power Supplies
For electrical requirements, refer to your Agilent 700 Series ICP Optical Emission
Spectrometers Site Preparation Guide.
Use of power boards or extension cables is not recommended.
If necessary, replace the power cord only with a cord equivalent to the one
specified in the site preparation guide.
Fuses
1FS1 and 1FS2
1CB1
NOTE
For safety reasons, any other internal fuse or circuit breaker is not operator
accessible, and should only be replaced by Agilent-authorized personnel.
Fuse information on the rear of the instrument is the most up to date.
Other Connections
IEEE 488
NOTE
Basic insulation is provided for single fault protection on the IEEE connector.
Gas Supplies
The installation of compressed or liquid gas supplies must comply with the rules
and/or regulations imposed by the local authorities responsible for such use in the
workplace.
Liquid or gaseous argon and nitrogen may be used with Agilent ICP-OES
spectrometer systems. Agilent recommends the use of liquid gases, which are
purer, more convenient and cheaper per unit volume.
Agilent 700 Series ICP Optical Emission Spectrometers User's Guide
T6.3 AH 250 V, IEC 127 sheet 5, 5 x 20 mm
Circuit breaker 30 A Fast trip
19