Rear Panel Connectors - BEC MX-221P Quick Start Manual

Rear Panel Connectors

INTERFACE
4G/LTE Antenna
1 Connectors
(Main/Aux)
2 Power Source
Power Jack
3
(DC IN)
4 RESET
Gigabit Ethernet
5
(LAN 1 / PoE)
Gigabit Ethernet
6
(LAN 2 / WAN)
7 SIM Card Slots
3
SMA female connectors.
Manually screw the cellular antennas tight to the female connectors
Connect to Main if decide to use single antenna instead of two
Power ON/OFF switch
(1) Power Switch ON: if want to power up by the supplied DC power adapter
(2) Power Switch OFF: if want to power up by a PoE injector
Connect the supplied Power Adapter to this jack
After the device is powered on, press it 6 seconds or above: to restore to factory
default settings (this is used when you cannot login to the router, e.g. forgot your
password)
Ethernet LAN: Connect to a 10/100/1000Mbps Ethernet device
:
Ethernet PoE Connect to an 802.3at Gb PoE injector to provide power to the
MX-221P.
Ethernet LAN: Connect to a 10/100/1000Mbps Ethernet device
Ethernet WAN: Software configurable in the GUI. Connect to a broadband device
such as a cable modem, ADSL/VDSL modem or fiber modem
SIM 1 : Insert the mini SIM card (2FF) with the gold contact facing down
SIM 2 : Insert the mini SIM card (2FF) with the gold contact facing up
SIM 3 : Insert the mini SIM card (2FF) with the gold contact facing down
Push the mini SIM card (2FF) inwards to eject it
* Power off the MX-221P before inserting or removing the SIM card(s)
BEC MX-221P Triple-SIM 4G/LTE Router
MEANING