Mounting
March 2020
3.4
Mount the I.S. barrier
Use this procedure if you are mounting an MVD
Procedure
1. Snap the barrier onto a 1.38 in (35 mm) DIN rail. You can mount it in either
2. Hook one end of the end clamp over the DIN rail.
3. Position the end clamp snugly against the barrier.
4. Tighten the screw until the end clamp is securely fastened to the DIN rail.
5. Close the cover and fasten the clamps.
Figure 3-4: Barrier mount on DIN rail
14
Figure 3-3: Wall mount
direction.
To remove the barrier from the rail, lift the bottom lock.
Installation Manual
™
™
Direct Connect
I.S. barrier.
MMI- 20032352
Micro Motion HPC