Initial Set-Up For Schulte Sdx-110, Sdx-117 And Rdx-110 Snow Blowers; Initial Set-Up For Schulte Sdx-117 Snow Blower - Schulte FM-350 Operator's Manual

Initial Set-up for Schulte SDX-110, SDX-117 and RDX-110 Snow Blowers

Remove the snow blower's three point arms and
re-inset them in the frame tubes so that the pins
are below the center line of the tubes. Push them
in so that the pins are as close as possible to the
snow blower.
IMPORTANT: Rotate the snow blower's parallel
shaft gearbox so that the PTO input shaft is in
the lower position. If the parallel shaft gearbox is
not rotated to its low position the front drive shaft
will be damaged when the snow blower is raised.
To rotate the parallel shaft gearbox to the low
position, remove the two (2) ¾ X 2-1/2 bolts,
washers and locknuts that bolt the 'interplate' to
the snow blower frame. Rotate the gearbox and
'interplate' 180 degrees and reinstall the ¾ X 2-1/
2 bolts, washers and locknuts.The front mount
frame's top link will be pinned to the 24-3/8",
middle hole position on the 3PT mast.

Initial Set-up for Schulte SDX-117 Snow Blower

Remove the snow blower's three point arms and re-inset them in the frame tubes so that the pins are below the
center line of the tubes. Push them in so that the pins are as close as possible to the snow blower.
IMPORTANT: Rotate the snow blower's parallel shaft gearbox so that the PTO input shaft is in the lower
position. If the parallel shaft gearbox is not rotated to its low position the front drive shaft will be damaged when
the snow blower is raised.
FM-350 10/14
© 2014 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-7