Concluding Safety Instructions And Practices - Schulte FM-350 Operator's Manual

All Safety Shields, Guards and Safety devices including (but not limited to) - the Chain
Shield, Cross Shaft Shield, Gearbox Shields, and PTO integral shields must be used and
maintained in good working condition. All safety devices should be inspected carefully at
least daily for missing or broken components. Missing, broken, or worn items must be
replaced at once to reduce the possibility of injury or death from entanglement.
DO NOT weld or repair rotating Blower components. Welds and other repairs may cause
severe vibration and/or component failure resulting in parts being thrown from the blower
causing serious bodily injury. See your Authorized Dealer for proper repairs.
Ensure any remote starting system is inoperative before servicing or cleaning the machine.
Inadvertent engine start up could result in entanglement or runover causing serious injuries
or death.
Use only OEM specified shear pins as replacement pins. The use of incorrect shear pins
can cause failures in the Snow Blower rotating components resulting in property damage
and/or serious bodily injuries.
All Safety Shields, Guards and other Protective Safety devices should be used and
maintained in good working condition. All safety devices should be inspected carefully at
least daily for missing or broken components. NEVER REMOVE PROTECTIVE SHIELDS
AND GUARDS!
When shields or guards are removed to access areas for maintenance, they must be
replaced and be in good condition before operating. Missing, broken, or worn shields,
guards, and other protective devices must be replaced at once and prior to operation to
reduce the possibility of injury or death from thrown objects, entanglement, or contact.
2)

CONCLUDING SAFETY INSTRUCTIONS AND PRACTICES

In addition to the design and configuration of this Implement, including Safety Signs and Safety Equipment,
hazard control and accident prevention are dependent upon the awareness, concern, prudence, and proper
training of personnel involved in the operation, transport, maintenance, and storage of the machine. Refer
also to Safety Messages and operation instruction in each of the appropriate sections of the Tractor and
Equipment Manuals. Pay close attention to the Safety Signs affixed to the Tractor and Equipment.
FM-350 10/14
© 2014 Alamo Group Inc.
SAFETY
(SSB-17)
(SSB-19)
NEVER MODIFY OR CUT PROTECTIVE SHIELDS OR GUARDS!
Safety Section 1-15
(SSB-9)
(SSB-14)
(SWS-
(SG-18)