Tractor Requirements; Rops And Seat Belt; Tractor Safety Devices - Schulte FM-350 Operator's Manual

2. TRACTOR REQUIREMENTS

Operating the implement with a tractor that does not meet the following requirements may cause tractor or
implement damage and potentially be a danger to the operator and passersby.
Tractor Requirements and Capabilities
• Certified approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
• Tractor Safety Devices .................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
• Tire Spacing ..................................... Set tires minimum width of 60" inside to inside of tires
• Tractor Horsepower, Maximum ........ 250 HP (186 kW)
• Tractor Horsepower, Minimum ......... 85 HP (63 kW) for SDX-960 and RDX-960, 140 HP (104 kW) for
• Tractor Hydraulic Requirement......... 3 remote circuits with a minimum total hydraulic output of 10 GPM at
• Tractor PTO...................................... 1000 RPM for SDX110, RDX-110, SDX-117 and SDX960, 540 RPM

2.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.

2.2 Tractor Safety Devices

If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO
with the PTO master shield missing or in the raised position. OPS-U- 0004
FM-350 10/14
© 2014 Alamo Group Inc.
OPERATION
SDX-110, RDX-110 and SDX-117
1200 PSI. An additional circuit is required if the snow blower has a
rotating drum.
for SDX960 only
Operation Section 4-4
(SG-7)