Schulte FM-350 Operator's Manual page 33

Dimension 'C' is measured from the front cap on the forward frame tubes C-1, to the back of the rear frame bolt
plates C-2.
Reinstall the 8-5/8 X 7" bolts and locknuts that clamp the frame together. 4 of the bolts will pass through
aligning holes in the rear frame section. Insert the bolts from the bottom up. These holes are used to lock the
inner and outer frame sections together. They are positioned at 2-1/2" intervals. It may not be possible to
exactly position the frame to match dimension 'C'. Use the closest position to dimension 'C'. The maximum
allowable extension for the two drive shafts that run inside the frame is 84-1/2" as measured between the cross
and bearing kits. The center steady bearing mount may have to be repositioned in order to not exceed this
length.
FM-350 10/14
© 2014 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-3