Starting The Tractor; Engaging The Power Take Off (Pto); Operating The Tractor And Snow Blower Or Plow - Schulte FM-350 Operator's Manual

8.1 Starting the Tractor

The procedure to start the tractor is model specific.
Refer to the tractor operator's manual for starting
procedures for your particular tractor. Consult an
authorized dealer if the starting procedure is
unclear. Ensure the 3-point control lever is in the
lowered position and the PTO is disengaged before
starting the tractor.

8.2 Engaging the Power Take Off (PTO)

Before engaging the PTO, make certain that the area is clear of bystanders and passersby. Set the tractor
engine speed at approximately 1,000 RPM before engaging the PTO. Shift the PTO control to the ON position,
and slowly increase the engine speed until the PTO is operating at the rated speed. If you here unusual noises
or feel abnormal vibrations, disengage the PTO immediately. Inspect the snow blower to determine the cause
of the noise or vibration and repair the abnormality. OPS-SB-0017
Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment.
shield if it is damaged or missing.

9. OPERATING THE TRACTOR AND SNOW BLOWER OR PLOW

THE OPERATOR MUST COMPLETELY UNDERSTAND HOW TO OPERATE THE TRACTOR AND FRONT
MOUNT SNOW BLOWER OR PLOW AND ALL CONTROLS BEFORE ATTEMPTING TO OPERATE. The
operator must read and understand the Safety and Operation Sections of the snow blower, plow, front mount
frame and tractor operator's manuals. These manuals must be read and explained to any operator who cannot
read. Never allow anyone to operate the front mount snow blower, plow and tractor without complete operating
instructions.
To ensure the safety of the operator, bystanders and equipment, the operator must become familiar with any
obstacles or hazards that are in the work area. Special attention should be paid to foreign debris, rough terrain,
steep slopes, passersby and animals in the area.
Only operate the snow blower or plow in conditions were you have clear visibility in daylight
or with adequate artificial lighting. Never snow blow in darkness or in conditions where you
cannot clearly see at least 100 yards in front and to the sides of the Tractor and Implement.
Make sure that you can clearly see and identify passersby, steep slopes, ditches, drop-offs,
overhead obstructions, power lines, debris and foreign objects. If you are unable to clearly
see these types of items, discontinue snow removal.
FM-350 10/14
© 2014 Alamo Group Inc.
OPERATION
(S3PT-8)
Operation Section 4-14
Always replace any