Sharp MX-B467F User Manual page 71

Understanding the printer menus
Menu item
Paper Size/Type
Tray [x]
Multipurpose Feeder
Manual Paper
Manual Envelope
Substitute Size
Off
Statement/A5
Letter/A4
All Listed*
Configure MP
Cassette*
Manual
First
Note: An asterisk (*) next to a value indicates the factory default setting.
Media Configuration menu
Universal Setup
Menu item
Units of Measure
Inches
Millimeters
Portrait Width
3–52 inches (8.50*)
76–1321 mm (216*)
Portrait Height
3–52 inches (14*)
76–1321 mm (356*)
Feed Direction
Short Edge*
Long Edge
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Specify the paper size or paper type loaded in each paper source.
Set the printer to substitute a specified paper size if the requested size is not
loaded in any paper source.
Notes:
•
Off prompts the user to load the required paper size.
•
Statement/A5 prints A5‑size document on statement when loading
statement and statement‑size jobs on A5 paper size when loading A5.
•
Letter/A4 prints A4‑size document on letter when loading letter and
letter‑size jobs on A4 paper size when loading letter.
•
All Listed substitutes Letter/A4.
Determine the behavior of the multipurpose feeder.
Notes:
•
Cassette configures the multipurpose feeder as the automatic paper
source.
•
Manual sets the multipurpose feeder only for manual-feed print jobs.
•
First configures the multipurpose feeder as the primary paper source.
Description
Specify the unit of measurement for the universal paper.
Note: Inches is the U.S. factory default setting. Millimeters is the
international factory default setting.
Set the portrait width of the universal paper.
Set the portrait height of the universal paper.
Set the printer to pick paper from the short edge or long edge
direction.
Note: Long Edge appears only when the longest edge is shorter
than the maximum width supported.
71