Maintaining The Printer; Adjusting The Speaker Volume; Networking - Sharp MX-B467F User Manual

Maintaining the printer

Maintaining the printer
Warning—Potential Damage: Failure to maintain optimum printer performance, or to replace parts and
supplies, may cause damage to your printer.

Adjusting the speaker volume

Adjusting the default internal speaker volume
The speaker volume will reset to default value after the session is logged out, when the printer wakes from
Sleep or Hibernate mode, or after a power‑on reset.
1
From the control panel, navigate to:
Settings > Device > Preferences > Audio Feedback
2
Select the volume.
Note: If Quiet Mode is enabled, then audible alerts are turned off.
Configuring the fax speaker settings
1
From the home screen, touch Settings > Fax > Fax Setup > Speaker Settings.
2
Do the following:
•
Set the Speaker Mode to Always On.
•
Set the Speaker Volume to High.
•
Activate the Ringer Volume.

Networking

Note: For information on installing the wireless network adapter, see the setup sheet that came with the
adapter.
Connecting the printer to a Wi‑Fi network
Make sure that Active Adapter is set to Auto. From the home screen, touch Settings > Network/Ports > Network
Overview > Active Adapter.
1
From the home screen, touch Settings > Network/Ports > Wireless > Setup On Printer Panel > Choose
Network.
2
Select a Wi‑Fi network, and then type the network password.
Note: For Wi‑Fi‑network‑ready printer models, a prompt for Wi‑Fi network setup appears during initial
setup.
122