Change Factory Settings Via Hardware Jumpers - Bacharach Neutronics 5100E Operation Manual

Maintenance and Troubleshooting
4.1.2.17 220 Volt Line Voltage – NOT USED, DO NOT CHANGE

4.1.3 Change factory settings via Hardware Jumpers

4.1.3.1 Analog Voltage Output
The Analog voltage output must be configured using the hardware settings (see Figure 19). In addition, the
software settings must match the jumper settings. Software changes are made via the Control panel User
Setup menu (section 4.1.1), or the Service Port RS-232 User Setup menu (section 4.1.2.7).
Manual Part Number:
C5-06-4900-08-0
Revision Level: C
ECO 8029
File Name: MN-A-0008 Page 4-16