Bacharach Neutronics 5100E Operation Manual page 29

Starting up and Commissioning the System
When the warm-up period is complete, the Model 5100E will check the sensor signal, update the display
and status LED's, and enter into the appropriate system mode according to programmed parameters (refer
to the Software Setup Log that is supplied by the factory, for the configuration details of your Model
5100E). Once the analyzer reading has stabilized, the user may apply an instrument air source to the
sensor to check the system. Allow the new reading to stabilize. It should take about 30 seconds for the gas
to sweep out the sample lines, depending on the length.
Manual Part Number: Revision Level: C File Name: MN-A-0008 Page 2-13
C5-06-4900-08-0 ECO 8029